18
Connecting the AC Adaptor
Connect the AC adaptor as follows:
1. Connect the AC adaptor cable into the power port on the notebook.
2. Plug one AC adaptor cable into the adaptor.
3. Connect the AC adaptor cable to grounded 100- or 240-volt, 50- or 60-Hz AC power outlet.
CAUTION
•
Do not cover or place objects on the AC adaptor. Keeping the adaptor clear of
objects lets the adaptor cool properly during use.
•
Only use the AC adaptor that comes with your notebook. Although other
adaptors look similar, using them can damage your notebook.
Powering The Notebook On and Off
To power on, locate the power button (or switch) and press or switch it on.
CAUTION
This equipment uses an ungrounded power cable. Replace the cord if it becomes
damaged. The cord must be rated for at least 250VAC at 10 amps, and must
indicate international safety agency approval. The plug must be a type appropriate
for the country where it is used. Check with your local dealer for HAR
(Harmonisation certification mark) type 18 AWG (American Wire Gauge), 2
conductor cord, or better. Obtain replacement cords at an authorised service centre.
The replacement must be of the same type and voltage rating as of the original cord.
Using the Battery
Note
Although the battery is fully charged at the factory, transit and shelf time may
reduce the initial battery charge. We recommend that the first time you use your
notebook, you connect it to AC power using the AC adaptor. This also recharges your
battery.
When the battery capacity is low, always respond by immediately saving your data, and
connecting your notebook to the AC adaptor. If an AC adaptor is not available, change the
battery using the battery replacement procedure.
For more information, please refer to:
Introducing Your NEC VERSA
→
Replacing
the Battery.
Page
20
If you do not take any action, the notebook will automatically go into Hibernation (Save To
File) mode.
