NEC Univerge SV9100, Programming Manual

Page: 513 / 954

SV9100 Programming Manual 2-473
Program:
34
Description
Use Program 34-01 : E&M Tie Line Basic Setup to define the basic settings for each E&M Tie line.
Program 34 : Tie Line Setup
34-01 : E&M Tie Line Basic Setup
Level:
IN
Input Data
Trunk Port Number 001~400
Item
No.
Item Input Data Default Description
Related
Program
01 DID/E&M Start
Signaling
0 = 2nd Dial Tone
1 = Wink
2 = Immediate
3 = Delay 1 Set the start signaling mode for
DID and Tie trunks. DID and
Tie trunks can use either
immediate start or wink start
signaling. 22-02
02 Receive Dial Type
for E&M Tie Line
0 = DP
1 = DTMF
2 = MF 1 10-09
03
E&M Dial-In Mode 0 = Specify Extension
Number (Intercom)
1 = Use Conversion
Table (NTT)
0
Determine if the incoming Tie
Line call should be directed as
an intercom call or if it should
follow the DID Translation
Table in Program 22-11.
22-11
04
E&M Line Dial Tone
0 = Disable (No)
1 = Enable (Yes) 1
Enter 1 if the Tie Line should
send dial tone to the calling
system after the call is set up.
Enter 0 if the Tie Line should
not send dial tone.
05 System Toll
Restriction
0 = System
1 = Each extension 0 Determine if an incoming Tie
Line call should be subject to
Toll Restriction. 21-05