NEC Univerge SV8100, Programming Manual

Page: 677 / 986

Programming Manual 2 - 641
Program
51
Description
Use
Program 51-01 : NetLink System Property Setting
to define the
parameters of the NetLink feature.

Each system must be set with its own information.

When the NetLink System ID is changed (Item 01), the system must be reset.
Program 51 : NetLink Service
51-01 : NetLink System Property Setting
Level:
IN
Input Data
Item
No.
Item Input Data Default
01
NetLink System ID
This is the ID of each NetLink system.
Setting should insure that no overlap
occurs between nodes.
0~50
(0 = No operation) 0
02
Primary Candidate Order
When the Primary system is turned off
or disconnect from network, this value
is used to select a new Primary
system. Smaller number is higher
priority.
If this value is the same number, the
System ID (PRG 51-01-01) is referred,
and the system which has the smaller
number is selected as Primary system.
1~50 30
03
Secondary System Flag
0: NetLink is dynamically established
based on Node List in PRG 51-03-01.
Primary System will be selected in the
order which the system wakes up.
1: The system connects with Top
Priority Primary System.
If Top Priority Primary System was not
found, the system searches Primary
System like this setting is 0.
0 = Disable
1 = Enable 0