NEC UNIVERGE NEAX 2000 IPS, Manual

Page: 81 / 244

CHAPTER 2 INSTALLATION
– 71 –
NWA-008855-001 Rev.1.0
avch2001.fm
NOTE:
IP Address is required when you change the assigned data. Be sure to keep a record of the IP
Address together with the MAC Address on the back side of an IP-CS.
When the IP Address is unknown, read the IP Address in the following procedure.
Start up the command prompt on the PC and execute “arp-a”. PCs (part) which can communi-
cate are displayed in list form.
For a PC that is not displayed on the list in spite of connecting physically, execute “arp-a” after
performing following either.
• Turn the IP-CS Power on again.
• Send Broadcast Ping. (Example: For 10.2.168.0/24, “ping 10.2.168.255”)
(c) Set the IP Address of the Default Gateway
Command: set dgw
Example:
IP Address of the Default Gateway: 10.41.207.254
The “set done” message is indicated when the IP-CS has received assigned data normally.
Assigned data can be read by entering “show dgw” command.
>arp-a
Interface: 192.168.0.15 on Interface 2
Internet Address Physical Address Type
192.168.1.17 00-20-af-f5-8a-30 dynamic
192.168.0.23 00-40-c7-57-92-ef dynamic
>set dgw 10.41.207.254
SETUP OF IP-CS