Setup procedure
This guide describes the procedures from removing the thin client from its box to getting
it ready for use. Perform these procedures according to the instructions in this guide.
* When UWF is enabled, the settings specified in Steps 6 to 8 are lost after the terminal is
restarted. (In US310e, UWF is enabled by default.)
Step 1 Check the accessory box
US310e
AC adapter
Getting Started (this document)
End user license
DVI-VGA adapter
Step 2 Install US310e
Decide where to locate US310e.
For details, see
Chapter 1
,
"3. Installation and Connection"
in the User's Guide.
Step 3 Connect the cables
Connect cables to US310e.
For details, see
Chapter 1
,
"3. Installation and Connection"
in the User's Guide.
*1. Use the supplied DVI-VGA adapter to connect a display that uses a VGA interface.
*2. The USB 3.0 port is disabled by the factory default settings.
Step 4 Turn on US310e
Press the power switch to turn on US310e.
Front view
Rear view
Power switch
Microphone
Hub
(multi-port repeater)
USB devices
USB devices
Display
(DVI or VGA)*1
AC adapter
Headphones and
computer speakers
Display
(DVI)
*2
