-69-
4.7
Using the operation panel to move cartridges
4.7.1
Load cartridge into drive
The following describes how to use the operation panel to move a cartridge from a specified
magazine slot into the drive.
In this example, the cartridge in slot 1 will be loaded into the drive #1.
1)
[Login]. See Section 4.3Login for detail.
2)
Select [Commands].
3)
Select [Move Cartridge] from [Commands].
4)
The screen to specify the Source and Destination is displayed.
Figure 4-10 Move Cartidge
5)
Select [slotxx] under [Source], and the slot where the cartridge is stored is displayed.
In this example, select slot01.
Figure 4-11 Select source Screen
