Ultra mobile SATA
Spinpoint N1C
80GB
120GB
HS08XJF
HS122JF
FEATURES
• MAX.60GB Formatted Capacity Per Disk
• SATA S.M.A.R.T Compliant
• High Speed Digital Signal Processor Based Architecture
• SATA 48-bit Address Feature Set
• Low Power HDC
• Multi-Burst On-The-Fly Error Correction
• Advanced Power Management Control
• SilentSeek™
• Fluid Dynamic Bearing Spindle Motor Technology
• Free Fall Sensor (optional)
Capacity
80 / 120 GB
Temperature
Interface
SATA 1.5Gbps
Operating
5 ~ 60
℃
Rotational Speed
5400 RPM class
Non-operating
-40 ~ 85
℃
Buffer DRAM Size
8 MB
Humidity (non-condensing)
Byte per Sector
512
Operating
8 ~ 90
％
Non-operating
8 ~ 90
％
PERFORMANCE SPECIFICATION
Linear Shock (1/2 sine pulse)
Capacity
DRIVE CONFIGURATION
ENVIRONMENTAL SPECIFICATIONS
Model
Average Seek time (typical)
14.0 ms
Operating, 2ms
600 G
Media Transfer Rate (Max.)
550 Mb/s
Non-operating, 1ms
1500 G
Interface Transfer Rate (Max.)
1.5 Gbps
Vibration
Drive Ready Time (typical)
4.0 sec
Operating
0.67 Grms
Altitude (relative to sea level)
RELIABILITY SPECIFICATION
Operating
-300 to 3.000 m
Non-recoverable Read Error
1 sector in 10^13 bits
Non-operating
-400 to 15,000 m
Controlled Ramp Load/Unload
600,000
PHYSICAL DIMENSION
ACOUSTICS
Height
8.0 mm
Idle
2.4 Bel
Width
78.5 mm
Performance Seek
2.6 Bel
Length
54.0 mm
Weight (Max.)
62 g
POWER REQUIREMENTS
Voltage
+3.3V
±
5%
Spin-up Current (Max.)
540 mA
Seek (typical)
1.30 W
Read/Write (typical)
1.60 W
* Note : Design and specifications are subject to change without prior notice.
Idle (typical)
0.40 W
1MB = 1,000,000 Bytes, 1GB = 1,000,000,000 Bytes
Standby (typical)
0.12 W
* Accessible capacity may vary as some OS uses binary numbering system for
Sleep (typical)
0.10 W
reported capacity.
* A small portion of the (8MB) buffer memory is reserved for firmware use.
1.8" N1C SATA product specification Rev.08
Match with 1.8" N1C SATA product manual Rev.07
