19
Chapter 2: Server Installation
Installing the Outer Rails on the Rack
Installing the Outer Rails
1. Confirm that the left and right outer rails have been correctly identified.
2. Release the small locking lever on the inside of the middle rail and push the middle rail
back into the outer rail.
3. Insert the square pins at the front of the outer rail into the square holes on the front of
the rack. Push until the latch snaps into place.
4. The outer rail is actually two pieces that slide to lengthen. Pull out the rear of the outer
rail, adjusting the length until the square pin assembly passes, then fits against the back
of the rear post. Be careful to keep the rail level.
5. Insert the square pins at the rear of the outer rail into the square holes on the rear of
the rack. Push until the latch snaps into place.
6. Repeat for the other outer rail.
Locking Lever on
Middle Rail
Figure 2-4. Installing the Outer Rails
Note:
Figure is for illustrative purposes only. Always install servers to the bottom of a rack first.
Summary of Contents for SX-Aurora TSUBASA A300-4
Page 1: ...SX Aurora TSUBASA A300 4 USER S GUIDE Revision 1 0b ...
Page 27: ......
