NEC SV8500, Manual

Page: 2148 / 3438

VOL.2-1895
MG-SIP16 [SCA-16SIPMG(US)]
23 SET Δ INTERFACE
This command is used to assign the Ether speed and the duplex type to each port on MG-SIP16.
Note 1:
When “Automatic Negotiation” is selected, “Full Duplex” is automatically applied to the interface. There-
fore, this command line will not appear for interface that is specified as “Automatic Negotiation”. When
100M is specified for Ether 1, the duplex type should also be assigned for Ether 1.
24 SET Δ IPADDRESS
This command is used to assign an IP address and a subnet mask to each Ether port on MG-SIP16.
• Ether1: LAN (Telephony Server network) side
• Ether2: WAN (SIP network) side
Note:
When the IP addresses of both LAN and WAN are assigned in the same segment, use Ether1 port only. Select
one port in the number of port setting, and assign Ether1’s IP address only. In this case, Ether2 is not used.
MG(SIP) > set interface
Ether(1) speed (AUTO=0/10M=1/100M=2):0
Ether(2) speed (AUTO=0/10M=1/100M=2): 1
Ether(2) duplex (Half=1/Full=2): 1
• Assign an Ether speed type to Ether 1.
0: Automatic Negotiation (default)
1: 10 Mbps (fixed)
2: 100 Mbps (fixed)
• Assign an Ether speed type to Ether 2.
0: Automatic Negotiation (default)
1: 10 Mbps (fixed)
2: 100 Mbps (fixed)
• Assign a duplex type to Ether 1 and Ether 2.
Note 1
1: Half Duplex
2: Full Duplex
MG(SIP) > set ipaddress
Use one-port only? Y/N=n
Ether[1]
IP address: 10. 1. 0. 1
Subnet: 255. 255. 255. 0
Ether[2]
IP address: 192. 168. 1. 1
Subnet: 255. 255. 255. 0
• Enter “n” when two ports are used.
Ether [1]: LAN side
• Assign the IP address (default: 0.0.0.0) for Ether [1].
• Assign the subnet mask (default: 0.0.0.0) for Ether [1].
Ether [2]: SIP network side
• Assign the IP address (default: 0.0.0.0) for Ether [2].
• Assign the subnet mask (default: 0.0.0.0) for Ether [2].