NEC SV8500, Manual

Page: 1021 / 3438

VOL.2-768
MG-BRI
11.7.6 List of Command Used for Configuration Data
SET: Command to assign the configuration data
Note:
The following commands are available for MG-BRI with the firmware versions: SP-3709 BRI MG BSC
PROG-A Issue 18 or later and SP-3708 BRI BOOT PROG-A Issue 8 or later.
Sub-command Function
1 DEFAULT_GATEWAY Assign the Default Gateway.
2 DHCP Assign whether to use DHCP Server or not.
3 DRS_IPADDRESS
Assign the IP Address and Port number of DRS. Only "Primary DRS"
needs to be assigned here.
4 EXTERNAL_MUSIC_LEVEL Assign input impedance of the external hold tone interface.
5 FAX_DETECTION_TIME Assign the effective switching time for FAX
6 HC_RCV_TIMER
Assign the Time-out value for Telephony Server health check waiting
process.
7 INTERFACE Assign the speed and activation mode of Ether controller.
8 LAN_ERROR_CHECK Assign the interval to detect LAN cable fall-off
9 OWN_IPADDRESS Assignment of IP Address and Subnet Mask of MG-BRI itself.
10 SIGNALING_PORT_NO Assign the port number to be used for signaling toward PHI.
11 SIGNALING_QOS
Assign the ToS value towards signaling (DRS) and H.245 Ready
Packet Session.
12 SMOOTH_PAD Assign the Smooth PAD
13 PRE-NEGOTIATION_PORT_NO
Assign the Port number to be used for sending/receiving H.245 Pre-
negotiation Packet.
14 RTP_START_PORT_NO Assign the Start number of Port to be used in RTP.
15 VLAN Assign the Tag VLAN information.
16 WARNING_TONE_CONTROL Assign whether to use warning tone when LAN failure or not.
Sub-command Function
1 CALL_HOLD Enable/Disable MG Based Call Retention.
2 RTP_STOP_DETECT
Assign RTP Receive Stop Detect timer used for MG Based Call Re-
tention.