NEC SIGMABLADE Series, User Manual

Page: 63 / 68

(English)
41
N8406-021 FC Pass-Through Card / N8406-015 FC SFP Module
You cannot establish a link. (The Link LED indicator does not turn on.)
1. Make sure that the cable has been installed properly.
2. Make sure the SFP module has been inserted to the SFP slot properly.
3. Refer to "
Network Cables
" (See page31) , and make sure that your cable meets the specification
required.
4. Make sure that the operating system in the CPU Blade recognizes the N8403-018 Fibre Channel
Controller.
5. Make sure that the fibre channel controller is operating normally. Confirm the error logs of the fibre
channel controller.
6. Make sure that the speed set for the N8406-021 FC Pass-Through Card is the same as that for a
fibre channel device at the connection destination.
Communication errors happen frequently.
1. Make sure the SFP module has been inserted to the SFP slot properly.
2. Refer to “
How to Install and Remove N8406-015 FC SFP Module
”(See page35) and
reinstall the module.
The status LED is illuminated in amber, not green.
1. Make sure that the module has been installed properly.
2. The SIGMABLADE monitor displays an error message.
See your User's Guide for N8405-019 EM Card error code information. For some error codes, you
may need to contact your sales company.
If the above troubleshooting instructions do not solve your problem, the module you are using may be
defective and you may need to contact your sales company or place of purchase.