English
English-8
Check DTV Signal
This function indicates the status for the Digital TV signal
level and the C/N.
1. On the “Tuner” menu page, press
button to select
“Check DTV Signal” and press SET button.
2. The status for the Digital TV signal level and the C/N will be
indicated. [Good/ Normal/ Weak: 0–100]
Network Settings
DHCP
This module will automatically attempt to establish a network
connection using DHCP when an active network cable is
connected. You can also manually attempt to connect by selecting
“DHCP” from the “Network Settings” on the “Tuner” menu page.
1. On the “Network Settings”, press
button to select
“DHCP” and press SET button.
2. Select “Yes” and press SET button to connect. (To confirm a
successful connection, select “System Information” on the “System”
menu page to check for the presence of an IP address.)
Static IP
If desired, this module can be manually configured to use
a static IP address by following the instructions below.
(Contact your network administrator to acquire the correct
values for each parameter before making the changes.)
1. On the “Network Settings”, press
button to select “Static
IP” and press SET button.
2. Press the numeric buttons on the remote control to input
the IP Address, Netmask, Gateway and DNS parameters.
When finished, select “Done” and press SET button to
manually implement the network settings.
IP Program Settings
This function sets the channel number for IP channel programs.
Add
1. On the “Tuner” menu page, press
button to select “IP
Program Settings” and press SET button.
2. Select “Add” and press SET button, then there are two
sub-menus listed.
(1) Unicast
Press
button to select “Unicast” and press SET button,
you will see the “Channel No” and “Port” to be typed. Then
press button to select “Add” and press SET button to apply.
(2) Multicast
Press
button to select “Multicast” and press SET button,
you will see the “Channel No”, “IP Address” and “Port” to be
typed. Then press button to select “Add” and press SET
button to apply.
Delete
1. Select “Delete” on the step 2 above and press SET button.
2. Type the “Channel No.” to delete the IP channel program.
Then press button to select “Delete” and press SET
button to apply.
