Quick Scan
This option should be used if you know which TV channels are used in your area.
●
Upon selecting the “QUICK SCAN” menu, the following
submenu will be displayed.
●
Please use up and down keys and select with the yellow key
the channels that are used in your area.
Start scan of the selected channels by pressing the green
key on your remote control.
It’ll take about 1 minute to complete this process.
Manual Scan
This option should be used if you want to scan a new channel from the pre-stored list or you want
to scan a channel which is not present in the pre-stored list.
Newly detected services will be added to those already stored.
●
U
pon selecting the “MANUAL SCAN” menu, the following
submenu will be displayed.
-1- Press “OK” key to activate the “Channel” mode (background
of channel number will change from yellow to red).
-2- Use L/R Arrow keys to go to desired channel number or
use numeric keys.
-3- Press “OK” to confirm.
-4- Press green key to start scan of the selected channel.
-5- The newly detected services will be added to the already
stored services.
Note: The Channel number and Frequency are according to
European CCIR standard. It is possible to change the
Frequency of the selected Channel in this menu
but this Frequency change will also be copied into the
pre-stored table
.
Antenna Power
In case an active antenna is used it can be powered (+ 5 Volt DC via the coax cable) by the PX-
TUDI-01. The default value is “ANTENNA POWER ON” NO
To activate this option, go to the ANTENNA POWER Menu and change “ANTENNA POWER ON”
with L/R key to “YES” (confirm Warning message with “OK”).
Initial Configuration
3-4
