Step 2
1.
Using Phillips head screwdriver, remove the four screws
that secure the OPS Slot Cover in place. Be sure to save
the 4 screws, you will need them to put the vented cover
on.
Step 3
1.
Using Phillips head screwdriver, remove the two screws
holding the handle in place.
2.
When handle is removed, place the two screws back into
the holes in the display but be sure to stop tightening as
soon as you meet resistance - screws will NOT go all the
way back in flush.
3.
Set handle aside
*For 40” and 46” LCD's, the handle will not be re-installed as it will
be in the way of accessing the OPS PC. For 55” displays, where
the handle is not blocking access to the OPS PC, removing the
handle is not required.
Revised 12-30-2011
Page
3
