NEAX2400 IPX Feature Programming Manual
NDA-24297, Issue 1
Page 641
Special Dial Tone
S-2
S-2
Special Dial Tone
General Description
This feature provides a distinctive dial tone to a user after the switch hook has been pressed, enabling the user to
activate a specific service feature.
Operating Procedure
1.
While connected with the first party, user presses the switch hook; receives SPECIAL DIAL TONE.
2.
User may activate a service feature, such as:
CALL HOLD
[C-6]
CALL TRANSFER-ALL CALLS
[C-11]
Service Conditions
1.
SPECIAL DIAL TONE rating is 350/440 Hz at 240 IPM.
2.
If dialing is not initiated within 12 seconds after receiving SPECIAL DIAL TONE, reorder tone will be
sent to the station. If the station has not gone back on hook or initiated dialing after 30 seconds of reorder
tone, the station will be placed in the LINE LOCKOUT [L-3] mode.
3.
If a user attempts CALL FORWARDING - ALL CALLS [C-5], - BUSY LINE [C-2] - DON’T ANSWER
[C-3], etc., SPECIAL DIAL TONE will be sent to that station after access code dialing.
Interactions
1.
No other programming is required. This tone is generated for all momentary pressing of the Hooking
feature applications.
2.
LINE LOCKOUT [L-3]: SPECIAL DIAL TONE is sent for 12 seconds, reorder tone for 30 seconds,
followed by Line Lockout.
Programming
ASYD
- System Data 1, Index 42, Bit 7. Is SPECIAL DIAL TONE continuous or a burst? 0/1:
Continuous/Burst. Leave as Data 0. System Data 2, Index 1, Bit 0 & 1. Assign as data “1” for both Bits
to provide CONSULTATION HOLD capability on a per-tenant basis.
System Data 3, Index 2. Assign data 91H for Normal (N) and Hooking (H) values.
