NEC NEAX 2400 IMX, System Manual, Page: 28 / 50

CHAPTER 3 ND-70684 (E)
Page 20
Revision 1.0
DATA PROGRAMMING
Data Programming Procedure (DSS/BLF)
2. Data Programming Procedure (DSS/BLF)
When assigning DSS/BLF data, perform the following procedure. “X” indicates the value should be tailored to
the existing system.
STEP 1: ASYD
Assign the DSS/BLF to an even-numbered LEN level. (In this example LV 0 is used.)
Assign a station to be used for programming DSS keys (KYNs 31-60) to the subsequent LENS. (In
this example, LV 1 is used.
STEP 2: AKYD
Assign key data for the 60 DSS keys. The upper 30 DSS keys (KYNs 1-30) are assigned using the
first port (LV 0 in this example) and the remaining lower DSS keys (KYNs 31-60) are assigned using
the second port (LV 1 in this example). Either KYN 1 or KYN 2 can be assigned first.
Be sure to assign the associated D
term
station number as the “Station Number of Prime Line.”
KYN 1 must be programmed as the DSS/BLF station that has been assigned by the ASDT command.
TN : X
STN : 200
LEN : 0 0 0 1 0 0 Even-numbered LEN level
TEC : 1 2 Fixed
RSC : X
SFC : X
TN : X
STN : 201
LEN : 0 0 0 1 0 1 Subsequent LEN level
TEC : 1 2 Fixed
RSC : X
SFC : X
TN : X
STN : 200 or 201
TP : 1 Buttons 1-40 are assignable
PRI : 0
PL TN : X
PL STN : 400 Enter the associated D
term
as a PL STN.
S : 0 = Off Hook Suppression is off
MWD : 0
LN PRE : 0 = Prime Line Pickup
KYN : 1
KY1 : 2 = Multi Line
KD : 0 = Line
TN : X
STN : 200 or 201 DSS/BLF number
RG : X