CHAPTER 4
ND-45895 (E)
Page 32
Revision 1.0
SYSTEM DATA PROGRAMMING
3. PROGRAMMING PROCEDURE
Initialize the AP using the procedure described in
section 3.1
, and perform system data feature programming in
accordance with Feature Programming.
For command details, refer to the Command Manual.
After all system data is assigned, set the SW1 switch of PN-AP00 as shown below to protect the data.
In the programming procedures described, the following symbolic conventions are used:
(1)
: 1
st
Data
(2)
: 2
nd
Data
: Initial Data
With the system data clear commands (CM00, CM01), the data with this marking is automat-
ically assigned for each command.
: System
Initialization
After entering the data, system initialization of the MP card is required.
: AP Initialization
After entering the data, AP initialization is required. (Toggle the Make Busy switch on the
AP card to UP and then DOWN.)
SW 1
ON
: POSITION TO BE SET
4
3
2
1
INITIAL
AP INITIAL
