NEC NE3108-005, User Manual

Page: 8 / 20

- 8 -
Avoid installation in extreme temperature conditions.
Immediately after the computer is powered off, its internal components such as hard
disks are very hot. Leave the computer until its internal components fully cool down
before installing/removing any component.
Connect firmly.
Please connect the product to the computer firmly. A loose connection can cause a
contact failure and can lead to smoke or fire.
Insert the power plug into the outlet as far as it goes.
Heat generation resulting from a halfway inserted power plug/cable (imperfect contact)
may cause a fire. Heat will also be generated if condensation is formed on dusty
blades of the halfway inserted plug, increasing the possibility of fire.
Do not use any unauthorized interface cable.
Use only the interface cable that comes with this product. Use of an unauthorized
interface cable may cause a fire when the electric current exceeds the rated flow.
Also, observe the following to prevent an electric shock or fire caused by a damaged
cord.
Ø
Do not use any damaged cable. (Replace a damaged cable with a new one of the
same specifications. Ask your sales agent for replacement.)
Ø Do not step the cable.
Ø Do not place any object on the cable.
Ø Do not alter, modify, or repair the cable.
When disconnecting a cable, push the latch, hold the connector, and pull it out straight.
Use only the Fibre Channel cable authorized by NEC and connects it to the proper connector.
Ignoring these instructions may cause a short circuit, resulting in a fire, electric shock, or
malfunction.
Do not use this product without Fibre Channel connector cover
.
Always cover each Fibre Channel connectors with the provided cover or properly connect this
product to a Fibre Channel cable.
If an abnormal fault occurs, it could cause this product to operate in a mode that may cause eye
or skin damage.
Avoid direct look into the laser beam
The “NE3108-005 Optical module for 10GBASE SR” is classified as a Class 1 Laser Product. A
class 1 laser will not be harmful to the human body. However, do not look directly into the LAN
port during operation. Keep any vacant LC connector covered with a dust cover when you do
not use it or you transport it.
Do not use or store this product in corrosive environment.
Avoid the usage or storage of this product in an environment which may be exposed to
corrosive gases, such as those including but not limited to: sulfur dioxide, hydrogen sulfide,
nitrogen dioxide, chlorine, ammonia and/or ozone.
Avoid installing this product in a dusty environment or one that may be exposed to corrosive
materials such as sodium chloride and/or sulfur.
Avoid installing this product in an environment which may have excessive metal flakes or
conductive particles in the air.
Such environments may cause corrosion or short circuits within this product, resulting in not only
damage to this product, but may even lead to be a fire hazard.
If there are any concerns regarding the environment at the planned site of installation or
storage, please contact your sales agent
．
CAUTION