13
Instructions
12
3.
Connect the intended plug
with the socket on the back
of the NEC Writer.
4.
Slide the NEC Writer into the
computer and fix it in the
computer cabinet with 4 screws.
To avoid damage to the NEC
Writer take care, that the screws
do not reach more than 1.5 mm
into the NEC Writers cabinet.
5.
Fasten possibly before removed
drives again in the computer
and close the housing cover.
Refer to the Guide to Opera-
tions that came with the
computer for help with this step.
Drive usage
Inserting a Disc
1. Press the Eject button. The disc
tray will be ejected by about
10mm.
2. Pull the disc tray all the way
open by hand.
3.
Set the disc into the shaft in
the centre of the tray with
the label side facing up.
4.
Press the disc tray into the
DVD R/RW drive calmly by
hand.
Removing a Disc
1.
Press the Eject button. The disc
tray will be ejected by about
10mm.
2.
Pull the disc tray all the way
open by hand.
3. Lift the edge of the disc
strongly, pressing the shaft in
the centre of the tray.
4. Press the disc tray into the
DVD R/RW drive calmly by
hand.
Note: If an eject prohibit
command has been received
from the computer, the disc
tray will not be ejected even if
the Eject button is pressed.
5 Connector
This Connector includes Power
I/O BUS and Audio Line Out.
Installation
Configuration
The drive configures itself
independently over the connector.
Note: Not all computer hardware
supports the intended automatic
configuration. Usually this
causes that after the drive
assembled the computer any
longer booting. In such case
the drives firmware bust my
changed by qualified
personnel.
Installing in a host computer
With the installation of Slimline
drives you have to consider that
dimensions and connections for
this was developed for the usage
in portable computer and are
standardized. If the Slimline drive
is not target for a standard
Slimline system, additional
adapters must be procured from
an appropriate expert trader.
1. Turn off the computer, other
peripherals and unplug all the
cords and cables. Then remove
the computer cover, face plate,
mounting clips, and keeper
bracket. Refer to the Guide to
operations that came with your
computer for help with this step.
2. Slide the NEC Writer into the
computer in such way that you
are able to connect the
intended plug.
Rear View
5
