64
4. LCD Menu
This chapter describes the menus displayed in the LCD screen on the projector’s control panel and their functions. For basic opera-
tions of menus, refer to the projector’s operation manual.
4-1. List of Menu
Menus in parentheses are menus for our service personnel. Normally, these menus cannot be used. If you are logged in to the
projector with Installation privileges, you cannot use [FactoryDefault] - [LAN] (page 69).
Main menu
Submenu
Description
Reference
page
Title Select
“Title Memory Name”
Selects the title of the signal to be projected.
TEST Pattern
Selects the test pattern to be projected.
Configuration
Lamp Setup
Adjust
Adjusts lamp brightness.
Lamp Mode
Selects the lamp to use.
Lens Control
Lens Position
Adjusts the position of the projected screen.
Focus Zoom
Adjusts the size and focus of the projected screen.
Reset
(FactoryDefault)
Returns the settings to their default values. Selects between preset
buttons and titles only, LAN settings only and all settings.
Lamp Usage
Initializes the usage time of the lamp.
Filter Usage
Initializes the usage time of the air filter.
Fliter Cleaning
Initializes the air filter usage time (for confirming the filter cleaning
time).
(Fan Usage)
Initializes the usage time of the fan.
(Douser Count)
Resets the number of times the douser has been used.
(Setup)
Douser Setup
Sets the douser open/close state.
Panel Key Lock
Locks the buttons on the projector’s control panel so that they
cannot be operated.
Auto Key Lock
Enables or disables Auto Key Lock.
3D Connector
Sets the signal input terminal for a 3D image system (3D terminal or
GPI/O terminal).
Unlit Mode
Sets the projector operation when the lamp does not turn on.
Off Timer
Sets the time until the projector power is turned off automatically.
Message
Sets the time to display the message indicating the air filter
replacement cycle.
Silent Mode
Selects whether to use the status indicator, buzzer, indicators on
the control panel and backlight.
(Installation)
Option Slot
Configures the device installed in slot (only when the projector is in
standby mode).
Orientation
Sets the projection method and cooling fan operating mode.
Lens Type
Sets the type of lens (supports or does not support the lens
memory function) attached to the projector.
Lens Calibrate
Performs calibration on lens units that support the lens memory
function (only when the projector power is turned on).
Lens Center
Moves the lens shift position to the center.
Baudrate
Sets the PC control connector (RS-232) data transmission speed
(bps).
Date/Time
Sets the date and time on the projector.
Fan Speed Mode
Sets the cooling fan operating mode.
Fan Noise Reduction
Sets the silent mode of the cooling fan.
(Memory)
Lamp
The content of the selected lamp memory (lamp mode and lamp
output power value) can be overwritten with the current settings.
Lens
The content of the selected lens memory can be overwritten with
the current settings.
