NEC N8803-034, User Manual

Page: 32 / 44

- 32 -
(1) PCI Card Edger
Connector to be inserted into the PCI slot (64bit 33/66MHz PCI, 66/100/133/266MHz PCI-X)
of the computer.
(2) Bracket
Bracket to fix this product to the extended slot of Computer.
Hint
„ When fixing this product to a PCI slot optimized for the standard type, replace
the bracket with the attached standard one.
(3) Fibre Channel Connector
Connector (LC Connector) used to connect this product to a Fibre Channel device.
Do not remove dust cover when not connected to Fibre Channel device.
(4) LED
Two LED give a visual indication of the operating state. The slow blink rate is 1 Hz; the fast blink is 4 Hz;
the flashing state is an irregular on/off appearance reflecting program activity.
Green LED Yellow LED State
Off Off Wake-Up Failure (Dead Board)
Off On POST Failure (Dead Board)
Off Slow Blink Wake-Up Failure Monitor
Off Fast Blink Failure in POST
Off Flashing POST Processing in Progress
On Off Failure While Functioning
On On Failure While Functioning
On 1 Blink 1Gbps Link Rate
–
Normal, link up
On 2 Blinks 2Gbps Link Rate
–
Normal, link up
On 3 Blinks 4Gbps Link Rate
–
Normal, link up
Slow Blink Off Normal
–
Link Down
Important
„ If the product fails at POST, please check the following items.
-
Is the product installed in the computer correctly?
- Are all Fibre Channel cables and power cords connected correctly?
(5)IEEE Address
IEEE Address of the product is displayed by this label.
Hint
„
The IEEE address correspond to the lower 12 figures of Worldwide Name(WWN) of the
product