Operation and Maintenance
Service representatives subordinate to or authorized by NEC provide services of the cage with use of
genuine parts and high technical capabilities. You can get the services for your own convenience.
For the services, contact the NEC sales department or representatives.
Removing or Replacing N8154-20F
Remove or replace the cage in the following procedure:
1.
Turn off the power of the server and disconnect the power cables from the receptacles.
2.
Remove all the HDDs installed in the cage.
Notice
Before removing HDDs, note the installation order of the HDDs.
3.
Remove the side cover on the server. Disconnect all the cables from the cage.
4.
Open the front door, remove the four screws fixing the cage, and pull out it toward you from the
server slowly.
CAUTION
Take care not to touch the left and right guide rails inside the cage.
5.
To replace the cage with new one, perform steps 5 to 8 in "Step 2 Installing N8154-20F in Server",
and install the removed HDDs into the original slots.
6.
Install the removed side cover on the server as it was.
Summary of Contents for N8154-20
Page 14: ...4 6 ネジを 2 本外し FDD スロットダミーカバーを取り外す 7 本体シャーシ前面から皿ネジ 2 本を外す 8 本体装置の右側面が下になるようにしてゆっくりていねいに倒す ...
Page 15: ...5 9 本体装置の底面にある六角ネジ 2 本を外す 10 HDD ケージフレーム側面からネジを 2 本外す 11 HDD ケージフレームをＬ字型の溝に沿って 持ち上げて移動させる ...
Page 18: ...8 17 2 5 インチ HDD ケージに添付されているダミーカバーをネジ 7 本で固定する 18 手順 6 で外した FDD スロットダミーカバーをネジ 2 本で固定する ...
