English-40
“SCHEDULE”/“OFF TIMER” function is not working
properly
•
The “SCHEDULE” function will be disabled when the
“OFF TIMER” is set.
•
If the “OFF TIMER” function is enabled and the power to
the LCD monitor is turned off when the power supply is
interrupted unexpectedly, then the “OFF TIMER” will be
reset.
Snowy Picture, Poor Sound in TV
•
Check antenna/cable connection. Use new cable if
necessary.
Interference in TV
•
Check components for shielding, move away from
monitor if necessary.
RS-232C or LAN control is not available
•
Check RS-232C or LAN cable connection.
•
Check “CONTROL” setting in “EXTERNAL CONTROL”.
•
Check the “ID=ALL REPLY” setting in “EXTERNAL
CONTROL”.
The touch panel does not respond
•
Make sure that PIP mode is not selected.
•
Check the input signal setting.
•
Make sure that STANDBY setting in TOUCH PANEL in
ADVANCED OPTION is “ON”.
•
Make sure that PC SOURCE setting in TOUCH PANEL in
ADVANCED OPTION is “AUTO”.
•
Using slot 2 type PC: Make sure the slot 2 type PC is
connected properly.
•
Using external computer: Make sure the USB cable is
connected properly.
•
If the STANDBY setting in TOUCH PANEL in ADVANCED
OPTION is set to “ON”, change it to “OFF” and back to
“ON” again.
The response of the touch screen is not correct
•
Avoid direct sunlight or strong light on the screen.
•
If there are some obstacles near the TOUCH screen, it
may malfunction.
•
Refl ective bar and camera module may be dusty or dirty
(see page 15 Figure 1), wipe gently with a soft cloth.
The computer’s power management does not work
•
It is recommended to choose “S1” at the “Power
Management” item in the BIOS (abbreviation of Basic
Input / Output System) computer’s setup screen.
Either light vertical or horizontal stripes may appear, depending on the specifi c display pattern. This is no product fault or degradation.