English-6
3. Height adjustment is locked by a lock switch. Place a hand on top of the stand and push the screen down to the lowest
position. Slide the lock switch to unlock the stand (
Figure B.1
).
NOTE:
Handle with care when unlocking the stand.
Place your hands on each side of the monitor screen, tilt it to the maximum angle then lift it to the highest position
(
Figure B.2
).
CAUTION:
The cable holder cannot be removed.
Figure B.1
Maximum Tilt
Cable holder
Figure B.2
4. Connect all cables to the appropriate connectors (
Figure C.1
). When using a USB cable, connect the B type connector
to the USB upstream port on the rear side of the monitor and the A type connector to the downstream port on the computer
(
Figure C.1a
). If using the cord from a USB device, plug it into one of the downstream ports of the monitor.
NOTE:
Incorrect cable connections may result in irregular operation, damage display quality/components of the LCD panel
and/or shorten the module’s life.
NOTE:
Adjustment of the volume control as well as the equalizer to other settings than the center position may increase the
ear-/headphones output voltage and therefore the sound pressure level.
Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor lowers the sound.
CAUTION:
Do not bind the USB cable. It may trap heat and start a fire.
Figure C.1a
A Type
B Type
A Type
B Type
Maximum Tilt
DisplayPort
USB upstream (USB Type-B)
Headphone
Highest Stand
Position
USB downstream
(USB Type-A)
Power cord
Figure C.1
D-SUB
Audio Input
HDMI
DVI-D
USB downstream (USB Type-A)
CAUTION:
Do not connect headphones to the monitor while you are wearing them.
Depending on the volume level, it may damage your ears and cause loss of hearing.