English-7
English
Figure C.1
Power cord
20° Tilt
DisplayPort
DVI
D-SUB
Highest
Stand
Position
Audio Input*
Headphone*
3. Place hands on each side of the monitor to tilt the LCD panel 20-degree angle and lift up
to the highest position.
4. Connect all cables to the appropriate connectors (
Figure C.1
).
NOTE:
Incorrect cable connections may cause abnormal operation, damage display
quality/components of LCD module and/or shorten the module’s life.
Use an audio cable without a built-in resistor. Using an audio cable with
a built-in resistor turns down the sound*.
CAUTION:
To raise or lower screen, place a hand on each
side of the monitor and lift or lower to the desired
height. When you use handle to lower screen,
you might pinch your fingers.
NOTE:
Adjustment of the volume control as well as
the equalizer to other settings than the center
position may increase the ear-/headphones
output voltage and therefore the sound
pressure level*.
CAUTION:
Do not connect headphones to the monitor while you are wearing
them.
Depending on the volume level, it may damage your ears and
cause loss of hearing*.
5. To keep the cables neatly organized, place them into the cable management
system that is built into the stand.
Place the cables in the hooks firmly and evenly (
Figure C.2
and
Figure C.3
).
NOTE:
Cable cover is not removable.
6. Please check that you can still rotate, raise and lower the monitor
screen after you have installed the cables.
Figure C.3
Power Cord
DVI Cable
D-SUB Cable
DisplayPort Cable
Audio Cable*
Figure C.2
Power Cord
DVI Cable
D-SUB Cable
DisplayPort Cable
Audio Cable*
Security Slot
7. Connect one end of the power cord to the AC inlet on the back of the monitor and the other end to the power outlet.
NOTE:
Please refer to the
section of this manual for proper selection of AC power cord.
* E233WMi only.
