previous page
next page
Page 1
Orientation
Set the projection method. Use the
▲▼
buttons to select
Front Floor, Rear Ceiling, Rear Floor or Front Ceiling.
Background
Select the background when there is no signal. Use the
▲▼
buttons to select Blue, Black, or Logo.
Signal Select
RGB:Normally select “Auto”. RGB and component signals are
switched automatically. If the signal does not switch when
component signals are input, select the “Component”.
Video & S-Video:Set the video mode. When “Auto” is
selected, NTSC 3.58, NTSC 4.43, PAL, PAL 60 or SECAM is
selected automatically.
(NTSC 4.43 and PAL 60 are not identified automatically when
the LT series projector is used. To view in one of these
modes, select the mode from the pull-down menu.)
Summary of Contents for MT40 -
Page 24: ...Image Options Menu Use to select Image Mode or Video Mode then press the s or ENTER button ...
Page 29: ...Noise Reduction Select the level Off Low Medium or High ...
Page 53: ...MAGNIFY button Press this to adjust the picture up to 400 ...
Page 58: ...LED This flashes when any one of the remote buttons is pressed ...
