6
MENU
EXIT
POWER ON
STANDBY
2
3
4
5
6
7
8
9
0
1
2
5
4
8
9
6
7
0
3
1
Power button (POWER ON)
Press this button to turn the power on.
2
Standby button (STANDBY)
Press this button to turn the power off.
3
Number buttons
4
MENU button (MENU)
This button turns the OSD screen on and off.
5
,
6
,
7
and
8
Direction button
Use this button to select the settings on the OSD screen.
9
EXIT button (EXIT)
This button returns the OSD to the previous screen.
0
SET button (SET)
This button saves on the selection on the OSD screen.
Remote control
Handling the remote control
Install the remote control batteries
This requires two AA batteries. Install the batteries as shown in the diagram below.
A. Press end slide to open the cover
B. Align the batteries according to the (+) and (-) indications inside the case
C.Replace the cover.
Wireless remote control extension cable
CAUTION:
Incorrect usage of batteries can result in leaks or bursting. NEC recommends the following battery use:
• Place the batteries properly according to the [+] and [-] indicators.
• Batteries have different characteristics depending on type, so do not mix batteries of different types.
• Do not combine new and old batteries. Doing so may shorten the life of new batteries, or cause liquid leakage from old batteries.
• Remove dead batteries immediately to prevent battery acid from leaking and causing a malfunction. Do not touch leaked battery acid as it may irritate the
skin. Carefully wipe the acid with a cloth.
NOTE:
•
Other than to install the batteries, do not open the remote control.
•
If you do not intend to use the Remote Control for a long period of time, remove the batteries.
Attention
•
Do not subject to strong shock.
•
Do not expose to water. If the equipment is exposed to water, immediate wipe away the water.
•
Avoid exposure to heat and steam.
Remote control sensor
Power indicator
Power button ON: Green light turns on
Power button OFF: Green light flashes then turns off
