English-13
English
3. After selecting your preferred EDID mode, hold down the (+) plus button and the (-) minus button simultaneously for over
2 seconds again. Then displayed (Information) OSD and Selected (Landscape) EDID data is displayed as (FIXED). Then
confi rm the EDID line (Portrait/Landscape) on the “INFORMATION” OSD.
4. Click the (+) plus button or (-) minus button once to close the “INFORMATION” OSD.
NOTE:
When using the “Portrait” setting, the display controller does not need to rotate the image in the video ram. In most
applications, this setting is preferable. However, if there is a need to rotate the image by the display controller, the
“Landscape” setting may be preferable.
Switching input source
Please operate input source change following the procedure mentioned below.
1. The (+) / (-) buttons are located in the back of the display. Press either button twice, and the present operating state appears.
Present operating state
2. With the present operating state displayed, press and hold both the buttons for 2 seconds. The switching input source
screen appears.
With the screens above displayed, select a input source using the (+) plus button or the (-) minus button.
Select a DisplayPort
Select a DVI
3. Switching the input source, press and hold both the buttons for 2 seconds. And the present operating state with the selected
input source appears.
Current signal input source is confi rmed on the INPUT description of PRESENT STATE OSD.
Input source
HINT:
In order to apply the confi guration change, make sure to press and hold both (+) and (-) buttons for over 2 seconds
after moving the cursor, otherwise the screen disappears in 15 seconds and the confi guration cannot be switched.
Summary of Contents for MD211G5
Page 1: ...MD211G5...
Page 3: ...English...
