33
3. Convenient Features
❹
Changing Eco Mode/Checking Energy-Saving Effect
Using Eco Mode [ECO MODE]
The ECO MODE (NORMAL and ECO) increases lamp life, while lowering power consumption and cutting down on
CO
2
emissions.
Four brightness modes of the lamp can be selected: [OFF], [AUTO ECO], [NORMAL] and [ECO] modes.
[ECO MODE]
Description
Status of LAMP
indicator
Status of
ECO indi-
cator
[OFF]
The lamp brightness is 100%.
Off
Off
[AUTO ECO]
Lamp power consumption will be controlled between
[OFF] and [ECO] automatically according to picture
level.
NOTE: A bright gradation may be less visible depending on
the image.
Steady
Green light
Steady
Green light
[NORMAL]
Lamp power consumption. (approx.81% brightness on
M402W/M402X/M352WS/M332XS and approx. 76%
on M362W/M362X/M302WS) The lamp life will extend
by lowering the lamp power.
[ECO]
Lamp power consumption (approx. 60% brightness).
The lamp life will extend longer than the one on NOR-
MAL mode by controlling power appropriate for the
lamp. The maximum power becomes equivalent to the
power in NORMAL.
To turn on the [ECO MODE], do the following:
1. Press the ECO Button on the remote control to display [ECO MODE] screen.
2. Press the ECO button again to select a mode you wish.
• Each time the ECO button is pressed, the choices will be changed:
OFF
→
AUTO ECO
→
NORMAL
→
ECO
→
OFF
TIP:
• The leaf symbol at the bottom of the menu shows the current selection of ECO mode.
NOTE:
• The ECO MODE and DYNAMIC CONTRAST features control the lamp power. Some pictures may become extremely bright when
using both ECO MODE and DYNAMIC CONTRAST features to control the lamp power. To avoid this phenomena, turn off the ECO
MODE and DYNAMIC CONTRAST.
• Immediately after the menu item is selected for [ECO MODE], the screen may flicker. This is not malfunction.
• The [ECO MODE] can be changed by using the menu.
Select [SETUP]
→
[GENERAL]
→
[ECO MODE].
• The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.]
→
[USAGE TIME].
• The projector is always in [NORMAL] for 90 seconds after the lamp is turned on and while the POWER indicator is blinking green.
The lamp condition will not be affected even when [ECO MODE] is changed.
• After a lapse of 1 minute from when the projector displays no-signal guidance, a blue, black or logo screen, [ECO MODE] will
automatically switch to [ECO].
• If the projector is overheated in [OFF] mode, there may be a case where the [ECO MODE] automatically changes to [NORMAL]
mode to protect the projector. When the projector is in [NORMAL] mode, the picture brightness decreases. When the projector
comes back to normal temperature, the [ECO MODE] returns to [OFF] mode.
Thermometer symbol [ ] indicates the [ECO MODE] is automatically set to [NORMAL] mode because the internal temperature
is too high.
