English-6
Contents
Your new NEC LCD monitor box* should contain the following:
Setup Manual
Audio Cable*
3
Base Stand
LCD monitor
(Base Stand not connected)
Setup
Manual
DVI-D to DVI-D
cable*
3
Mini D-SUB 15 pin to
Mini D-SUB 15 pin*
3
DisplayPort cable*
2
Screws*
2
VESA plate*
2
Power Cord*
1
• LCD monitor with tilt base
• Power Cord*
1
• Video Signal Cable (15-pin mini D-SUB male to 15-pin mini D-SUB male)*
3
• Video Signal Cable (DVI-D to DVI-D cable)*
3
•
Video Signal Cable (DisplayPort cable)*
2
• Setup Manual
• Base Stand
• Audio cable*
3
•
VESA plate*
2
• Screws*
2
*
Remember to save your original box and packing material to transport or ship the monitor.
*
1
Type of power cord included will depend on the where the LCD monitor is to be shipped.
*
2
US only.
*
3
Europe only.
The model name is on the label.
Label
Quick Start
To attach the Base to the LCD stand:
1. Place monitor face down on a non-abrasive surface (
Figure 1
).
NOTE:
Handle with care when monitor facing down, for avoiding damage to the front control keys.
2. Please pivot base 90 degrees as shown in
Figure 1
.
NOTE:
Handle with care when pulling the stand.
3. Attach the base stand to LCD monitor and properly lock screw of base stand bottom (
Figure 2
).
NOTE:
Reverse this procedure if you need to re-pack the monitor.
Figure 1
Figure 2
Screw
