(English)
24
Description
Name
Description
1. ID LED
The LED is intended to identify the Switch Module in the Blade Enclosure. The LED is lit
by software command.
2. STATUS LED
Indicates the Switch Module status.
Contact your service representative if it does not go on green in five minutes after the
Blade Enclosure is powered on.
3. Ejector
Use this lever to install or remove a Switch Module in/from the Blade Enclosure.
4. Serial Port
Used as a DB-9 management serial port.
5. Uplink port
(XFP module slot)
XFP module connectors for optional fiber uplink
6. LINK LED
Indicate the link status of each LAN port.
Off
Link not established
On (Green)
Link established
7. ACT LED
Indicate the activity of each LAN port.
Flash (Green)
Data being transmitted or received
8. RESET Switch
Press this switch to restart the Switch Module.
Pressing the RESET switch reboots this Switch Module, loses the configuration
data not to save in the flash memory, and temporarily disconnects
communication with the network.
NOTE:
The Switch Module works with the Blade Enclosure. It does not
have a POWER switch.
1
2
3
4
5
6
7
8
N8406‑026
