CHAPTER 3 NOTES ON TARGET SYSTEM DESIGN
User’s Manual U16647EJ1V0UM
30
Table 3-2. MICTOR Connector Pin Functions
Pin No.
Signal Name
I/O
Description
1 and 2
GND
−
Connect to GND
3
DCK
IN
Clock input
4
V
DD
−
Connect to V
DD
for on-chip debugging (for target system power ON
monitoring)
5
DMS
IN
Transfer mode selection input
6
DRST
IN
Reset input to on-chip debug unit
7
DDI
IN
Data input
8
RESET
IN
System reset input (leave open when not used)
Note 1
9
DDO
OUT
Data output
10
FLMD0
IN
Flash mode input (leave open when not used)
Note 2
11
N.C
−
Open (not connected)
12
RESERVE
−
Open
13
N.C
−
Open (not connected)
14
PORT0_IN
−
Connect to GND
15
N.C
−
Open (not connected)
16
PORT1_IN
−
Connect to GND
17
GND
−
Connect to GND
18
PORT2_IN
−
Connect to GND
19
GND
−
Connect to GND
20
RESERVE
−
Open
21 to 38
GND
−
Connect to GND
Notes
1.
This may be required if DRST of the target device is an alternate-function pin and the initial value
of the OCMD0 bit changes according to the reset source. (Refer to section
3.2.8 RESET
.)
2.
This is required when the target device incorporates flash memory.
3.3.3 2.54 mm pitch 20-pin general-purpose connector
If using a 2.54 mm pitch general-purpose connector as the IE connector, mount a connector that can be
connected to the IE connection cable on the target system.
Figure 3-11 and Table 3-3 show the IE connector pin configuration and the pin functions, respectively.
