CHAPTER 7 HARDWARE SPECIFICATIONS
User's Manual U13502EJ2V0UM00
82
•
PG-FP3 pins not wired
Keep in mind the following points:
•
Open the CLK signal of the PG-FP3 to supply a clock to the microcontroller from the target.
•
Open the SCK signal when using a UART.
•
Open the SO signal when using IIC.
•
Open the HS signal when not using SIO + handshaking.
The pin configuration of the target interface connector and specifications of the interface cable are given below.
[Pin configuration]
Pin
Signal name
IN/OUT
Specification
1
GND
−
Common signal
2
SI (RxD)
IN/OUT
Serial data I/O (3-wire, UART, IIC)
3
SO (TxD)
OUT
Serial data output (3-wire, UART)
4
SCK
OUT
Serial clock output in 3-wire, IIC mode
5
CLK
OUT
Clock output to target (Select 16, 8, 4, or 2 MHz.)
6
_RESET
OUT
RESET signal output to target (Low: RESET ON)
7
V
DD
IN/OUT
V
DD
input/output to target (Select I/O with select switch.)
8
V
PP
OUT
V
PP
output to target
9
HS
OUT
Handshaking signal output of 3-wire + handshaking communication
Summary of Contents for Flash Memory Programmer PG-FP3
