NEC Flash Memory Programmer PG-FP3, User Manual

Page: 36 / 95

CHAPTER 3 STARTING AND STOPPING
User's Manual U13502EJ2V0UM00
36
•
Option setting
The Options dialog box is used for detailed setting of the target and is displayed when the [Setting..Option]
command is executed.
This dialog box is used to set the erase time, write time, and convergence time. These parameters are
automatically set to the default values when the parameter file is loaded.
The new values become valid only when the check box is checked before the [Setting..Option] command is
executed.
Do not change these parameter settings unless it is necessary. Changing any of these parameters may damage
the device.
Because the above settings are necessary for correct interfacing with the target, be sure to perform them when
starting FLASHPRO3. The information set is recorded in the PG-FP3 and is used to interface with the target
when the PG-FP3 is used in stand-alone mode. Any setting that is changed can be saved with the [File..Type
Save] command. To perform setting again, use the [File..Load] command.
Caution Load the parameter file each time FLASHPRO3 is started, even though the file was loaded the
previous time FLASHPRO3 was used. The PG-FP3 updates its settings to prevent a wrong
target from being selected by reloading the parameter file each time FLASHPRO3 has been
started. This is done because the target may be damaged if it is accessed with wrong setting
of the parameter file.
3.4 TERMINATING THE APPLICATION
To terminate the application, execute the [File..Exit] command.
After terminating the application, turn off power to the PG-FP3.
Caution The target may be damaged if power to the PG-FP3 is turned off or if the target is disconnected
while a command is being executed. To end operation of the PG-FP3 while a command is being
executed, execute the [Procedure..Cancel] command to cancel the current processing, then
terminate the application and turn off power to the PG-FP3.