background image

 

       Partition Check: 

 

     sdg:<6> I/O error: dev **:**, Command ********, sector 0 

   

  I/O error : dev **:**, Command ********, sector 0 

   

  unable to read partition table 

 

 

Limitations 

The following limitations apply to the Express5800/320Lb FT Linux.  

Please read the 

limitations below carefully to ensure that they are followed.   

 

System Hardware 

320Lb systems purchased with or previously running the Windows Operating 
System cannot be loaded with the FT Linux Operating System.  The following 
conditions may occur: 

„

 

The system may hang after a PCI Module breaks and is restoring to service.  

The root cause is due to insufficient decay of 3.3V during a 1 second power-off 
cycle during the PCI module bring-up after a failure.  This condition has been 
corrected for new 320Lb systems purchased with the Windows Operating 
System after mid-November 2004.  

 

Note:

 

This limitation does not apply on any 

systems ordered and preloaded with FT Linux at the 
factory. 

 Memory 

Limit 

The FT Linux OS currently have a 3GB (6x512MB) memory upper limit. 

 

Restrictions 

The following limitations apply to the Express5800/320Lb FT Linux.  

Please read the 

restrictions below carefully to ensure that they are followed.   

List of Restrictions 
 

 Restrictions 

LAN card that is not connected to the network 

If LAN cards connected to the device are not used (i.e. cables are not connected), 
the ports on those cards are recognized as BROKEN state, turning the status color 
of data viewer ([FtServer]-[PCIModule]-[Ethernet board]) as well as Operation 
Window to red (abnormal).  Connect those LAN cards together using the LAN 
cables (cross cable) to avoid this status.   
 

Express5800/320Lb System Release Notes  5 

Summary of Contents for Express5800/320Lb FT Linux









Reviews: