NEC EXPRESS5800/120Le, User Manual

Page: 91 / 162

Upgrading Your System 4-11
!
CAUTION
Observe static precautions. Use an antistatic wrist strap.
Hold the processor only by its edges.
3.
Press down on the heat sink clip retention latch until it springs outward from
the fastener tab on the base of the ZIF socket of the processor that you are
removing. See Figure 4-8.
!
CAUTION
When performing the remaining steps in this procedure, do
not touch the thermal tape located between the heat sink
and the processor as the tape is easily damaged.
4.
Remove the heat sink clip by pulling it up and over the center of the heat
sink and detach the small end of the clip from the tab on the base of the ZIF
socket, as shown in Figure 4-8. Remove the heat sink.
Figure 4-8. Removing the Heat Sink Clip and Heat Sink
5.
Raise the ZIF socket lever to the up position. See Figure 4-9.