NEC ELECTRA ELITE IPK II, Installation Manual

Page: 22 / 72

2 - 2 CNF(16)-U20 ETU Setup
___________________________________________________________________________________
___________________________________________________________________________________
Document Revision 1A Electra Elite IPK II
1.2 Installation Precautions
The ETUs used in this system make extensive use of CMOS technology that
is very susceptible to static electricity. Static discharge must be avoided
when handling ETUs. Always use the following precautions.
Wear a grounded wrist strip anytime you handle an ETU.
Make all ETU DIP switch and jumper setting changes before inserting the
ETU in the KSU.
Carry ETU in a conductive polyethylene bag to prevent static electricity
damage.
S
ECTION
2 E
LITE
IPK II P
ROGRAMMING
The CNF(16)-U20 ETU can be programmed using a Multiline Terminal.
1. To program the system, the CNF(16)-U10 ETU should be installed in the
desirable slot.
2. Programming may be done using the PCPro, WebPro Application, or a Multiline
Terminal.
3. The CNF(16)-U10 ETU consumes 16 ports using ports 001~256.
4. Access the Electra Elite IPK II System Programming Speaker # * # * [system
password] Transfer.
Consult the System Administrator for system password.
5. Access Data Program 10-03-01 ETU Setup and enter the Slot number of
CNF(16)-U10 ETU to verify which ports are used. In the following example the
CNF(16)-U10 has been seated in slot 6:
Example: 10-03-01 Slot No 6
CNF port 01 Port 33
6. Port 33 [Extension 133] is the first port assigned to the CNF(16)-U10.
7. Dial Extension 133 to verify the CNF(16)-U10 ETU.
When installing the ETU, observe the following precautions to
avoid damage to hardware due to static electricity or to being
exposed to hazardous voltages.