14
Inserting a CD
1. Press the Load/Eject button. The CD tray will be ejected.
2. Place the disc in the center of the tray with the label side facing up.
3. Press the Load/Eject button. The CD tray will be retracted.
Removing a CD
1. Press the Load/Eject button. The CD tray will be ejected.
2. Remove the disc.
3. Press the Load/Eject button. The CD tray will be retracted.
WARNING:
Do not forcibly push the CD tray in by hand. Doing so may result in damage.
Note:
If an eject prohibit command has been received from the computer, the
CD tray will not be ejected even if the Load/Eject button is pressed.
Emergency Eject
The procedure described below can be used to remove a disc from the
CD-ROM reader if the Load/Eject button is disabled by software or a
power failure occurs.
1. Turn off the power to the computer installed the CD-ROM reader.
2. Insert a steel rod (about 1.3mm in diameter) into the emergency eject
hole and push hard. The CD tray is ejected by about 10mm. Pull it all
the way open by hand.
A stiff paper clip may be used as a steel rod.
65mm
(AT LEAST 45mm IN LENGTH)
ECDR3001.PM5
99.1.13, 2:37 PM
15
