Redundant Power Upgrade Kit Installation Procedures 19
Installing the Server Side Panels
Use this procedure to install the two side panels on your server. (See "Removing
the Server Side Panels" earlier in this document for additional information.)
Install the side panels as follows.
1.
From the rear of the server align the locking tabs on each side panel with the
corresponding slots in the chassis.
2.
Slide each side panel towards the front of the chassis until it locks in place.
3.
Secure each side panel with its thumbscrews.
Powering Up and Testing the Server
Installation of the Upgrade Kit is now complete; power up and test the server.
Connect all cables and ac power cords as follows.
Note:
Make sure all cable connections are tight.
1.
As appropriate, connect all cables previously removed from the back of the
server.
2.
Connect an ac power cord from each of the power supplies to an ac power
outlet (see the following figure).
Plugging in the AC Power Cords
