35
- ORIGINAL INSTRUCTIONS -
MECHANICAL TROUBLESHOOTING
Possible Cause
Too heavy a grind on the final grinding passes.
Overhead clamps and tooling bar clamps not tight.
Cross slide lock handles not tight.
Grinding head lock handles not tight.
Loose gibs on the carriage.
Linear bearings on the grinding head carriage are bound
with grit, loose or damaged .
Checkout Procedure
Grind out reel using correct sparkout procedure as specified
in the Operators Manual.
Tighten all locking hand knobs, Four knobs on the tooling
bar, four knobs on the overhead bar clamp and two on the
overhead clamp swivels.
When using center brackets, insure the fixed center is tight
as well as the moveable center lock knob.
Tighten the horizontal and vertical cross slide lock handles.
Tighten the two lock handles on the adjusting arm slots
and one on the vertical height adjustment.
Adjust the gibs per the procedure in the adjustment sec
-
tion in this manual.
The lineal bearing must be preloaded to the traverse shafts
with no vertical movement. See manual adjustment section
for carriage linear bearing adjustments.
Lubricate the linear bearings per the procedure as speci
-
fied in this manual. Replace bearings if they cannot be
properly adjusted.
PROBLEM--Reel ground concave, convex or with irregular shape.
PROBLEM--Roundness of reel varies, High low reel blades are observed.
Possible Cause
Too heavy a grind on the final grinding passes.
Checkout Procedure
Grind out reel using correct sparkout procedure as
specified in the Operators Manual.
PROBLEM--Stock removal much different traversing left compared to traversing right.
The possible causes and checkout procedures are the same as listed above for concave, convex or
with irregular shape.
Summary of Contents for 181
