5
Operation
The Power Switch is located on the right rear of the 7XL unit. Press the
“I” side of the switch to turn the unit ON. The amplifier will begin its
power-up process once turned on.
Power Switch
The front of the 7XL contains 3 LED indicators, one per output channel:
CLIP –
Illuminates Red, it indicates a condition in which the signal is
clipping an output stage and automatically reducing signal level to
prevent the over load condition.
SIGNAL –
Illuminates Green, it indicates that the output is passing
signal normally.
NOTE: By factory default, A and B also monitor Signal/Clip of InA and
InB input stages.
Front LED Indicators
This is used to navigate and select through the presets. Push once to
access security level. Rotate to password “val = 10”. Push again to
access IP address and preset selection. Rotate again to select desirable
preset. Once desired preset is shown, push again to select preset.
Amplifier will now operate with selected preset.
NOTE: A Factory Restore can be accomplished by pushing and holding-in
the Encoder/Push Button while simultaneously pressing the Power Switch
ON. This will clear all user settings/presets and restore the unit to its
factory defaults.
Encoder/Push Button
Puts the amplifier into low-power consumption, or “Stand By”, mode. The
button will appear as back-lit Red when in the “Stand By” mode. Press
for >2 Sec to enter and exit Stand-By Mode.
Stand By Button
0
I
OFF
Readout for amplifier state and preset selection.
LCD Display
NEAR 7XL
B - IGS12 IG70V