NDS ZEROWIRE G2, User Manual

Page: 27 / 40

27 / 40
Set up and Installation | 27
4.14 Signal Strength and OSD Diagnostic Messages
When a receiver is connected to a monitor, self-explanatory diagnostic messages are displayed in the lower
left corner of the screen to inform the user of the receiver’s current status.
The messages will be displayed for 15 seconds, with the exception of Search for transmitter wireless signal
failed and No wireless signal detected: ss=0 vm=NONE .
Search for transmitter wireless signal failed and No wireless signal detected: ss=0 vm=NONE will be dis-
played until remedial action is taken.
When the No wireless signal detected: ss=0 vm=NONE message and/or the 1-bar graph are displayed on the
screen, the wireless link is unreliable and requires immediate remedial action .
The Signal Strength bar graph is displayed in the lower right corner of the receiver’s monitor for 60 seconds
at power up. It is also displayed when the link is established following a link disconnect.
When the link quality is poor or bad the bar graph is automatically displayed to alert the user that remedial
action is required .
The OSD messages are displayed below the signal-strength bar.
(1)
(1)
Signal-strength bar
OSD Messages
No wireless signal detected: ss=0 vm=NONE
No DVI/SDI signal detected
Receiving wireless signal
Trying to establish wireless link
Unable to establish wireless link
Searching for transmitter wireless signal
Search for transmitter wireless signal failed
Signal-strength bar graphs
Excellent link quality
Acceptable link quality
Bad link quality or link down, frequent pixilation and/
or screen “freeze”