Installing the Display | 7
Install the Display Controller
Before you install the display controller, choose a well-ventilated
location with an adequate amount of space. Excessive heat cannot
dissipate when display vents are blocked. Make sure a grounded
AC outlet is within easy reach.
Turn your computer off. Leave the power cord plugged into the
grounded outlet.
To install the controller board
1 Remove the computer cover and then the blank bracket from
the PCI Express slot.
2 Insert the display controller into the slot, align the connector pins,
and press the board down until it is firmly seated.
3 Secure the mounting bracket, and reattach the computer cover.
Installation Tips
• Graphics card. If you are using the display with another graphics
card and without the Dome CXtra software, use the instructions
shipped with that graphics card.
• Video mode. Although the GX2MP display can be used with either
a digital or analog video cable, the installation instructions in this
manual relate to the use of the display with the DVI cable. Use of
the display controller that shipped with the display, as well as the
DICal calibration feature of the Dome CXtra software, can only
be supported on the DVI-D interface.
• Multiple displays. Connect all displays to the video board before
you turn on the computer and install the driver.
