NDS ExpandOR, User Manual

Page: 14 / 25

6
6
Simultaneous Transmit/Receive Video
1. Press the power button until the ring illuminates.
ExpandOR can simultaneously receive and transmit streaming patient surgical video in the operating room/
procedure room from one ExpandOR to another ExpandOR in the hospital. The steps required to simultane-
ously transmit and receive surgical video to/from the intended ExpandOR within the hospital are shown be-
low. Prior to operating the unit, please confirm with your IT department that the ExpandOR
parameters are set appropriately for your specific use.
2. Press TRANSMIT button in front panel.
3. Press RECEIVE button on the front panel.
6. Stop transmitting by pressing the TRANSMIT button as shown in Step 2 above. Stop receiving by pressing
the RECEIVE button as shown in Step 3. The TRANSMIT LED and the RECEIVE LED turn off. If video was be-
ing recorded, ending receive also ends video recording, turning off the RECORD VIDEO LED.
If you want to record the video stream and/or capture images, verify with your IT department that the
ExpandOR is setup for video streaming and/or capturing images. If it is, then proceed as shown below. Start
recording video by pressing the
RECORD VIDEO button, as shown below, until the LED below it turns on. Stop
recording video by pressing the RECORD VIDEO button until the RECORD VIDEO LED turns off. See Record
Video Feature on page 9 for more information about this function.
5. Pressing the CAPTURE IMAGE button as shown below, causes the LED below it to flash. One image is
captured per button press. See Capture Still Feature on page 9 for more information about this function.