4
Document Number
DCV-00470
Date Released
Jul. 2020
Revision Number/Security level
R03 S2
Retrofit G6-300 + InvencoLink Wayne Vista 3V (US) Installation Guide
1 Introduction
The documentation provides some basic guidelines for installing the Optic 5 Touch/ G6-300 Outdoor
Payment Terminal (OPT).
This Retro-Fit Kit can be installed into either Side A or Side B of a Wayne Vista 3V dispenser;
•
For a single-sided installation, or if this Kit will be installed into Side A (i.e. the first side
installed) of a double-sided installation, it requires the pre-installation of UL Listed by Report
Retrofit Kit Part Number 6009-0008-8801 (InvencoLink Converter) before installation into the
dispenser.
The process is covered in §4.2 Pre-Installation Procedure of this instruction, by reference
to the instructions in that Kit.
•
For a double-sided installation, two of these Kits are required.
1.1
Tools Required
The following tools are required to mount the G6-300 OPT:
•
Torx T25 security screwdriver
•
Short Philips #1 screwdriver
•
Philips #1 screwdriver with >5” shaft
•
Flat 5mm screwdriver
•
Small adjustable spanner
•
Side cutters
•
Cable (zip) ties
•
Pliers
•
¼” Socket or Nut Driver
•
3mm Hex Key
•
3” wide jaw Vice Grips
•
Standard Vice Grips
•
7/32” Socket or Nut Driver
•
Flat File
•
Disposable drop cloths (eg large
kitchen cloths)
•
Magnets
•
Neodymium magnets
•
Small plastic bag
•
Nail polish
•
Hacksaw
WARNING
Do NOT
use power tools if working on a fuel station
forecourt.
Any spark could cause an explosion.
