08
INSTALLATION AND ADJUSTMENT
3. INSTALLATION AND ADJUSTMENT
3.1 General remarks
While we are confident about the ease and your ability to assemble the bike, we highly recommend a tune up and safety
check from a professional bike shop or industry partner.
3.2 Front Mudguard and Front Wheel Assembly
1. To install the mudguard, loosen the screw that secures the front light to the fork and remove the front light. Install the
mudguard and the front light in the order shown in image 1.
Tools you will need: 5mm Allen wrench, 10mm wrench.
2. Unscrew the two screws on both sides of the fork arms. Align the mudguard brace wires to the screw holes and screw the
two screws back onto the fork.
Tools you may need: 4mm Allen wrench.
3. Remove the protective device from the front hydraulic disc brake. Insert the front wheel (1) into the end of the fork (2).
4. Unscrew the spring and plastic cover at the end of the quick release and pass the quick release rod through the hub.
Tighten the axle nut (4) and close the quick release lever (5).
The lever should be on the opposite side of the brake, it must be pointed upwards (and aligned with the fork to prevent
snagging) and should be closed with noticeable counter pressure.
5. Make sure the brake rotor is centered between the brake pads (3). Adjust the disc brake until there is no obvious friction
sound between the brake and disc when turning the wheel. Please refer to (3.8.2).
2
3
3
1
5
4
2
2
5
4
1
