NCD Explora 700, Installing Manual

Page: 32 / 44

Installing Additional Memory
5-10 Installing Optional Equipment
4. Press the Return key to run the test once.
F Loop forever
E Loop until error
Q Main menu
<cr> Test once
Esc Abort testing
Enter choice? <CR>
If memory is good, a diagnostic code such as the following displays:
Pass -00000001
If an error is detected, a message such as the following displays:
Error: found 0000DEAD expected A5A5A5A5 at 2003FFFC RAM
March Test
Suspected bad component is SIMM 1 - SIDE 0
SIMM 1
indicates the slot number of a bad
SIMM
. If there are no errors, go
to Step 7. If errors are reported, continue with Step 5.
5. Remove the bad
SIMM
from the slot indicated and rerun the memory test
to confirm that the remaining memory is good.
6. Add a new
SIMM
and rerun the memory test to confirm that the newly
installed
SIMM
is good.
7. Exit from the test and return to the Boot Monitor by typing:
Enter test type? Q <CR>
8. Reset the computer by typing:
rs <CR>
For information about the Boot Monitor commands, refer to
NCD
ware
software documentation.