Installing Additional Memory
5-6
Installing Optional Equipment
Installing SIMMs
This section describes the installation of the
SIMM
s.
Caution
Electrostatic Discharge (ESD) can damage SIMMs and other components located on
the logic board. Make sure you touch a suitable ground before handling any
SIMM. If possible, set the NC on an anti-static mat and wear a grounding strap.
Always handle SIMMs
only
by the edges.
Your
NC
already has
SIMM
s installed. The
SIMM
slots, located on the front left
side of the logic board, are labeled
SIMM
1,
SIMM
2,
SIMM
3 and
SIMM
4. (See
Figure 5-5.) Observe the
SIMMs
currently in the slots and refer to Table 5-1,
“Explora 700 Memory Configurations,” on page 5-2 to determine your
configuration. Decide what you want your new configuration to be. If you
need to remove existing
SIMMs
, go to “Removing SIMMs” on page 5-8 and
then return to this section for installation instructions.
Note
SIMM
s should be installed in matched pairs in slots
SIMM
1 and
SIMM
2 or
SIMM
3 and
SIMM
4.
Figure 5-5 Location of the SIMM’s Slots
SIMM1
SIMM2
SIMM3
SIMM4
(Hidden)
Summary of Contents for Explora 700
