41
Safe Operating Instructions
TOWING PROCEDURE
OPENING THE HIGH PRESSURE CIRCUIT
•
Unscrew bypass valve (A) by 2 turns
RELEASING PARKING BRAKES
•
Remove the blocks (B) from the rear axle
•
Remove & dispose of the rubber plug from the
brake protector .
•
Place the 25mm steel flat over the drum.
•
Tighten the bolt (C) to the bottom of the threading
in the wheel motor.
•
Tighten the nut (D) until the motor shaft turns
freely, while holding the screw.
•
After releasing always insert a new rubber plug.
IMPORTANT: In some countries it may be illegal
to tow the dumper. It is your responsibility to
know the law in your own country
The dumper may only be towed using suitable towing equipment such as a
towing bar or cable. These must be fixed to either the towing hitch
(optional) or the tying down eyes at the front or rear axle.
The dumper may only be towed when the following steps have been
carried out. Failure to observe these tasks will invalidate any remaining
warranty and seriously damage the hydrostatic drive pump and wheel
motors.
•
Open the high pressure circuit on pump
•
Parking brakes released on both wheel motors
•
Max Towing speed: 2 Kmph
•
Max towing distance: 1 Km
Ensure the dumper is on a level
surface and that the wheels are
chocked to prevent it rolling away.
(A)
(B)
(B)
(D)
(C)