NBS Payment Solutions
9/60
User Manual
1.2 INSTALLING THE TERMINAL ON THE BASE
Install the terminal on the base so that both sets of contacts are properly mated.
1.3 CHARGING THE BATTERY
When is the battery to be charged?
•
On initial start up, charge the battery for 16 hours following the environmental conditions stated below.
•
When used daily the PORTABLE will recharge its batteries each time it is placed on its base. Charging
is automatic.
•
A completely discharged battery requires 8 hours for a complete recharge.
•
A fully charged battery can be expected to process 100 transactions.
Where is the battery to be charged?
•
The environment where charging takes place influences the battery lifetime. Do not expose the terminal
to extreme temperatures. Ideally the battery should be charged away from any heat sources (radiator,
etc) at an ambient temperature b15°C and +25°C.
•
Do not expose the terminal to moisture or rain.
Charging the battery using the base.
•
Place the portable on its base.
Charging using the car charger.
(The portable is out of its base)
•
Connect the power supply unit to the BA-USB adapter.
•
Connect this assembly to the slave mini-USB connector located on the
side of the portable.
•
Connect the power supply unit to the mains.
Check that the scrolling bar appears above the battery icon.
WARNING: The Battery installed in the terminal is not user serviceable. Only a
qualified technician may be authorized to open the unit and service the unit.
Summary of Contents for NBS5xxx
